Hello everybody!
I have a question. After loading the process in the studio, all elements in the studio are highlighted in gray. The process cannot be started. Rebooting the kernel does nothing. And it’s not clear to me what needs to be done for the studio to load the process. This happens in 50% of launches.
A clean install according to this would be good: Error INIT_1_125 or INIT_3_10 during installation or update
If the problem persist; send the log to support@robocorp.com
You can find the log here
Thanks for your reply. Yes, there was a problem with the installations (there were errors when updating regularly). I cleaned the Robocorp folders manually and only then was it possible to install.
I will try to use your advice.
